Our manufacturing facility at the Sanwer Road industrial area is built over an area of 30,000 sq.ft. It houses both laminated as well as aluminium tube manufacturing. Both areas are however built separately, with independent access. Laminated tubes are manufactured, capped and checked in a completely separate section in order to maintain a clear division of activity. Our factory location also houses the office block.
The aluminium collapsible tube manufacturing is further divided in three sections:
For more Information-
Select your tube and customize it as per your requirement from the following specifications
Sr |
Tube Diameter (mm) |
Tube Length (mm) |
Typical Capacity (GM) |
Available Nozzles |
Internal Lacquer |
Latex Lining |
Printing |
01 |
12.7 |
45-82 |
2.5 to 5 |
Open Nozzle (ON)
Closed Nozzle (CN)
Long Nozzle (LN)
Special Big Nozzle (SN) |
Please specify if required -
Internal Lacquer provides a non- reactive layer thus avoiding contact of filled product with aluminum. |
Please specify if required -
Latex lining facilitates better sealing of tube from the crimping end and is recommended for low viscosity products |
Multicolor options for base coating
High Gloss coatings
Metallic coatings
Up to four color printing |
02 |
13.5 |
60-85 |
5 |
||||
03 |
16.0 |
85-95 |
10 |
||||
04 |
19.0 |
100-105 |
15 |
||||
05 |
19.0 |
110-116 |
20 |
||||
06 |
22.0 |
120-130 |
25 to 30 |
||||
07 |
25.4 |
125-145 |
40 to 50 |
||||
08 |
27.0 |
145-165 |
50 to 70 |
||||
09 |
30.0 |
150-185 |
80 to 125 |
||||
1 For more Information- X
Contact UsDeepak Thakuria (CEO) Send Email
|